Superhard tooling · exporting to 48 markets
Technology

From diamond powder to a repeatable cutting edge.

Superhard tooling is a materials problem before it is a geometry problem. Our process controls both, then proves the result on your material.

PROCESS

Four controlled steps, one batch chain.

Material, sinter, edge and prove-out are not four departments. They are one route, and every step leaves a record.

01

Powder selection

Diamond or CBN grain is selected by size, shape and surface condition. The metal or ceramic binder is matched to the workpiece and the failure mode.

02

HPHT sintering

Blanks are sintered under controlled pressure and temperature. Each batch is logged with its pressure curve and density result.

03

Edge engineering

Laser cutting, wire EDM, grinding and honing are sequenced for the geometry. Edge radius and chamfer are measured, not estimated.

04

Prove-out on your material

The recommended grade is tested against the drawing: dimension, finish, tool life and failure mode. The process record goes with the shipment.

PROCESS FILM / 00:15

The process is not a slide.

Real footage of CNC drilling, coolant and chip evacuation. Cycle and parameters are confirmed by workpiece.

CNC DRILLING · COOLANT · CHIP EVACUATION15 SEC / PROCESS
MATERIAL DATA

Material properties, written into the process.

Typical values for selection; final data is confirmed by grade and drawing.

Laser cutting a precision metal component
E-modulusPCD 800–1,050 GPa / PCBN 580–680 GPa
Thermal conductivityPCD 500–700 W/m·K / PCBN 40–80 W/m·K
Max. service temperaturePCD 700 °C / PCBN 1,200–1,300 °C
Edge radius capability0.005–0.10 mm, measured
Typical tolerance±0.003–0.005 mm
TraceabilityPowder lot → sinter batch → edge route → final inspection