Superhard tooling · exporting to 48 markets
TECHNICAL NOTE

Edge preparation: the 0.02 mm that decides tool life

Why a polished edge is not always better, and how to specify hone size for interrupted cuts.

A superhard insert fails at the edge before it fails in the bulk. Edge preparation controls the stress concentration, the first contact and the heat path.

For continuous finishing, a small hone (R0.01–0.03 mm) keeps the edge sharp and reduces cutting force. For interrupted cuts, a larger hone (R0.05–0.10 mm) or a chamfer protects against micro-chipping at the cost of some force.

Specify it on the drawing

State the hone radius, chamfer angle and width, and whether the edge is laser-cut, ground or polished. If the operation is unstable, start with a tougher edge and optimise the process before reducing the hone.